Reduce gear noise, these two methods are reliable

　　We all know that noise problems are very troublesome, whether it is urban noise or rural noise.Noise not only makes people feel irritable, but also may have a bad effect on hearing.It is inevitable that gears will produce some noise during operation, so how to reduce gear noise?

　　1. Improve gear lubrication methods

　　For gear lubrication to reduce noise, we should not only start with the choice of lubricants, but also innovate gear lubrication methods, save lubricants, and improve gear use efficiency and reduce noise. Although studies have shown that centrifugal lubrication is effective The most effective way to reduce gear noise is to inspect the gear box within the specified time frame, and replace severely damaged and degraded gears in time. On this basis, drill a small hole at the bottom of the gear to use the characteristics of centrifugal force. The lubricant is injected through the small holes, and the used lubricant waste is also eliminated. This method can effectively cause effective friction between the gears and avoid gear transmission noise due to poor lubrication effects.

　　2. Tooth shape correction method

　　Due to the tooth profile error, the tooth tip meshing of the gear is generated, and the meshing accuracy is crossed. In order to improve the meshing accuracy, we use the tooth profile correction method to eliminate the noise of the gear. The effect is also very good. Use assorted to correct the meshing points of the gears so that the meshing points of the gears are distributed as close to the index circle as possible to improve the meshing accuracy of the gears.

　　The above are two ways to reduce gear noise, do gear lubrication work well, repair gear tooth profile, and reduce h gear noise.While the gear noise is reduced, the service life of the gear will also be extended. I hope that the introduction of the editor can help everyone.